EZ-Lam Surface Coat - Aluminum

(0) No Reviews yet
$104.50
SKU: ET-SC-ALUM-03-K-P

Details

Description

Aluminum Filled Surface Coat is a thick aluminum filled gel used to produce a hard, durable surface coat on high temperature epoxy molds. This system offers good brushing characteristics and is designed for use with E-Z Lam High Temp Laminating Resin. Its room temperature cure allows for quick lay-up of the mold on a room temperature master. The mold can be removed from the master and then post cured.

When combined, the mixture provides a pot life of 45 minutes at 75°F. The surface coat must undergo room temperature set for 24-48 hours at 75°F, followed by a tiered post cure cycle, starting at 150°F and ending at 300°F. Allow the part to cool in the oven prior to removal. The maximum operating temperature is 350 °F.

  • Shipping: Domestic Shipping via Ground Only

Technical

Physical Properties
Mix Ratio:
Weight: 100 parts A to 10 parts B
Pot Life:
150 gr. mass 45 minutes @ 75°F
Cure:
  • Room Temp Set 24-48 Hours @ 75°F followed by:
  • 4 Hrs. @ 150°F
  • 2 Hrs. @ 200°F
  • 2 Hrs. @ 250°F
  • 2 Hrs. @ 300°F and allow to cool
Shelf Life:
Twelve months when stored in tightly sealed containers at room temperature.
Color:
Silver/Aluminum
Technical Properties
Viscosity, Mixed:
Paste
Durometer D:
90 Shore
Specific Gravity:
1.55 gm/cc
Tensile Strength:
9,500 psi
Flexural Modulus:
19,000 psi
Compression:
29,500 psi
Max Temperature:
350°F

Please note: All data to be used as a guide only; not a specification.

Shipping

Restrictions
Due to U.S. Department of Transportation Hazardous Materials regulations and International Air Transport regulations we can only ship this product by domestic ground service within the contiguous United States.
Back

Ratings & Reviews

No reviews available

Be the first to Write a Review